Your Ultimate Surveillance Guide
To reset Chime Pro, unplug it, then wait 30 seconds before plugging it back in. Press andhold the setup button for 15 seconds until the light on the Chime Pro flashes blue. If you’re experiencing issues with your Ring Chime Pro and need to reset it, these steps can help. Resetting the device can often … Read more
To hardwire your Blink Doorbell, connect it to your existing chime wiring with a few essential tools. You will need a screwdriver, wire strippers, electrical tape, a voltage tester, and a power source for the doorbell. This method allows your doorbell to run off batteries while using the chime wiring for power, ensuring a continuous … Read more
If your Blink camera is offline, reconnect it by power cycling and checking your Wi-Fi connection. To get your Blink camera back online, power cycle the camera and check your Wi-Fi connection to ensure a stable connection. If the issue persists, replacing the batteries or moving the camera closer to the sync module may help … Read more
To connect a Blink camera to a WiFi extender, access the camera’s settings, navigate to network settings, select the extender’s network, and enter the password if prompted. Integrating a Blink camera with a WiFi extender effectively extends the camera’s coverage range. By establishing a direct connection, you can broaden the reach of your security system, … Read more
To determine if your Roomba is charging, simply check the battery status indicator or light ring on the robot by pressing the Clean button once. If the indicator shows a pulsing red light, it means the Roomba is currently charging but the battery is too low to start cleaning. A pulsing white light indicates that … Read more
To reset an Arlo Pro 2 camera, press and hold the Sync button on the top of the camera for approximately two seconds, then release the button. The camera’s LED will blink rapidly in blue to confirm the sync. If the LED blinks amber, the sync was not successful. Introducing the Arlo Pro 2 camera, … Read more
To reset a Blink camera to a new account, first, remove the camera from the old account. Then, set up the camera with the new account credentials. This process allows you to detach the camera from the previous account and connect it to a new one, enabling its operation under a different owner. Resetting a … Read more
