Want to hardwire your Ring Doorbell? Follow this simple guide. Hardwiring your Ring Doorbell ensures it always has power. No more charging batteries!

Tools You Will Need
Before you start, gather these tools:
- Screwdriver
- Drill
- Wire Stripper
- Level
- Voltage Tester
- Mounting Bracket
- Ring Doorbell

Step-by-Step Guide
Follow these steps to hardwire your Ring Doorbell:
Step 1: Turn Off Power
First, turn off the power. Go to your home’s circuit breaker. Turn off the power to your doorbell. Use a voltage tester to make sure no power is running.
Step 2: Remove Old Doorbell
Next, remove your old doorbell. Use a screwdriver to take out the screws. Gently pull the doorbell off the wall. You will see two wires.
Step 3: Attach The Mounting Bracket
Now, attach the mounting bracket. Place the bracket on the wall where the old doorbell was. Use a level to make sure it’s straight. Mark the screw holes with a pencil. Drill the holes. Attach the bracket with screws.
Step 4: Connect The Wires
This is an important step. You will connect the wires. Use a wire stripper to strip about half an inch of insulation off each wire. Connect the wires to the screws on the back of the Ring Doorbell. Tighten the screws.
Step 5: Mount The Ring Doorbell
Place the Ring Doorbell on the mounting bracket. Use the screws provided to secure it. Make sure it is tight and secure.
Step 6: Turn Power Back On
Go back to your circuit breaker. Turn the power back on. Check your Ring Doorbell. It should light up, showing it has power.
Step 7: Set Up Your Ring Doorbell
Follow the instructions in the Ring app. Connect your doorbell to your Wi-Fi. Complete the setup process. You are done!
Tips and Warnings
- Always turn off the power before working with wires.
- Use a level to ensure the bracket is straight.
- Check the voltage with a tester.
- Make sure the wires are securely connected.
Conclusion
Hardwiring your Ring Doorbell is easy. Follow these steps and tips. Enjoy a doorbell that always has power. No more battery worries!