Introduction:
A factory reset is a process that erases all of the data and settings on a device and returns it to its original factory settings. It is often used to fix a device that is malfunctioning or to remove unwanted data. In the case of an NVR (Network Video Recorder), a factory reset will erase all of the recordings and settings that have been configured on the device. This guide will provide step-by-step instructions on how to perform a factory reset on your NVR.
Step 1: Power off the NVR.
Step 2: Unplug the power cord from the back of the NVR.
Step 3: Locate the reset button on the back of the NVR. This is usually a small, recessed button.
Step 4: Use a paperclip or similar object to press and hold the reset button for 10 seconds.
Step 5: Release the reset button and plug the power cord back into the NVR.
Step 6: Power on the NVR.
Step 7: The NVR will now reset to its factory settings.
start:
1. Power off your NVR.
2. Unplug the power cord from the back of the NVR.
3. Press and hold the reset button on the back of the NVR for 10 seconds.
4. Plug the power cord back in and power on the NVR.
5. The NVR will begin the reset process and will eventually reboot.
6. Once the NVR has rebooted, the factory reset is complete.
Next:
1. Power off the NVR.
2. Press and hold the reset button on the back of the NVR.
3. While still holding the reset button, power on the NVR.
4. Release the reset button after the NVR starts up.
5. The NVR will now reset to its factory default settings.
Finally:
1. Log into your NVR using the IP address and credentials.
2. Go to the “System” tab, then select “Maintenance”.
3. Select “Factory Reset” and click “OK” to confirm.
4. Your NVR will now reset to its factory settings.
Tips and tricks:
1. Log into the NVR and navigate to the System Settings menu.
2. Select the Factory Reset option and click Yes to confirm.
3. Wait for the NVR to complete the reset process.
4. Once the reset is complete, the NVR will restart.
5. Log into the NVR again and reconfigure the settings as desired.
Troubleshooting issue for:
1. Make sure the NVR is powered off and all cables are disconnected.
2. Remove the hard drive from the NVR.
3. Press and hold the reset button located on the back of the NVR for 10 seconds.
4. Reconnect all cables to the NVR.
5. Power on the NVR.
6. The NVR will go through a factory reset and reboot itself.
7. After the reboot, the NVR will prompt you to set up the NVR again.
8. Reconnect the hard drive and configure the NVR.
Video:
Conclusion:
In conclusion, performing a factory reset on your NVR is a great way to restore it to its original state and ensure that all settings and configurations are reset. It is important to remember to back up any important data before performing a factory reset, as all data will be lost in the process. Additionally, it is important to ensure that the NVR is powered off and unplugged before beginning the reset process. With these steps in mind, you can confidently perform a factory reset on your NVR and restore it to its original state.
