Featured image for how to reset aqara camera doorbell
Image source: i.ytimg.com
Reset your Aqara Camera Doorbell in just 5 simple steps to restore factory settings and resolve connectivity issues quickly. Whether you’re troubleshooting or preparing to resell, this straightforward process ensures a seamless reset—just press and hold the reset button for 10 seconds until the LED flashes. No technical expertise required—get your doorbell back to optimal performance in minutes.
This is a comprehensive guide about how to reset aqara camera doorbell.
Key Takeaways
- Locate the reset button: Find the small hole on the device’s side or back.
- Press and hold: Use a paperclip to hold the button for 10 seconds.
- Watch the LED: Flashing light confirms the reset process has started.
- Wait for reboot: Allow 1–2 minutes for the doorbell to restart fully.
- Reconnect to app: Re-add the device in the Aqara app post-reset.
- Verify Wi-Fi settings: Ensure stable connection to avoid future issues.
Frequently Asked Questions
How do I reset my Aqara camera doorbell to factory settings?
To reset your Aqara camera doorbell, press and hold the reset button (usually on the side or back) for 10–15 seconds until the LED flashes rapidly. This will restore it to factory settings and erase all paired devices.
Why would I need to reset my Aqara camera doorbell?
A reset is often needed if you’re experiencing connectivity issues, pairing failures, or preparing to sell the device. It clears all configurations and allows you to set it up fresh.
Can I reset my Aqara doorbell without the Aqara app?
Yes, you can perform a physical reset using the hardware button. However, the Aqara app is required afterward to reconfigure settings and reconnect to Wi-Fi or your home network.
How long does it take to reset an Aqara camera doorbell?
The actual reset takes less than 30 seconds, but full reconfiguration—including Wi-Fi setup and app pairing—may take 5–10 minutes. Always ensure your doorbell is charged or wired during the process.
What should I do after resetting my Aqara doorbell?
After resetting, open the Aqara app, remove the old device from your account, and follow the setup process to re-pair your doorbell. Make sure your phone is close to the device for a stable connection.
Does resetting the Aqara camera doorbell delete cloud recordings?
Yes, a factory reset disconnects the device and erases local settings, but cloud recordings stored in your Aqara account remain safe. You’ll need to re-enable cloud storage after resetting and re-pairing.